DOMINOX guides
Each guide quotes the body that wrote the rule, with the date we read it.
From cut to joint: preparing copper tube
A square cut, a clean edge, then the flame.
Read the guide
Torch work near wood and insulation
Move it, shield it, and keep an extinguisher in reach.
Read the guide
Before you open a refrigerant line
The charge goes to a recovery machine, never to the air.
Read the guideThe tools these guides use
-
CT-650
CT-650 Tubing Cutter with Deburring Tool
One cutter from 3/16 to 2 inch copper, with a deburring pen in the box.
3/16-2in
-
212JF
212JF Stainless Heat Deflector Shield
Clips to the torch tip and keeps the flame off the wall behind the pipe.
304stainless
-
CT-308
CT-308 Refrigerant Recovery Plier
Clamps on a sealed copper line and pierces it, so the charge goes to your recovery machine.
4-8mm